Mechlyfe Slatra RDA – and again in the grid
At the end of the day, I suggest you enjoy, if possible, the creation of the Mechlyfe team. As you remember, they started with a mechanical mod, by the way, pretty cute. Now they took up atomizers, and started off the bat – they presented a drip on a grid, moreover, a double one. There is no information that it will be offered complete with a pilot project – it is likely that it will appear later.
Mechlyfe Slatra RDA
Brand developers never detach from the AmbitionZ Vaper reviewer . This new product is also washed down under his name.
Case Material: Stainless Steel
Atomizer Type: RDA
Capacity: Small
Diameter: 25mm
Height:30mm with drip type
Connector: 510, gold-plated pin
Weight: unknown
Color: see photo below
Options
– Slatra RDA
– 2pcs mesh
– screwdriver
– mesh holder –
hex key
– spare origins
– spare screws
– pin squeeze –
user manual
Appearance recognizable , however, to call it original, and even more memorable, is impossible with all desire. Normal such – medium – a pleasant bow, but no more. The engraving on the sidewall and some slimness in the upper part ended with decor elements.
In contrast to the pilot project, here the manufacturer has already offered five colors at once from the start – not bad, taking into account the brand’s small experience in the vape arena.
The drip type is made of resin, landing 810th. As you noticed, its color changes depending on the color of the case. He sits in a top cap with risks. It is they who will come to the aid of the new owner in adjusting the airflow.
The side skirt is perforated on the sides with many holes. Most likely, she is sitting motionless on the deck, however, for a “maneuver” she was left with a small move – this is only an assumption. As you can see, the cutouts on the top cap are stepped, so they will overlap the causal air inlets gradually.
The deck is quite interesting. The developers did not follow the path of least resistance, and did not use the replicated, but pretty well-established, profile constructs.
The creators themselves call it a three-post. So in the upper part there is a massive clamping pad with a large screw, by the way, at the top of the latter there is a spout hole when using the novelty paired with a squonk pin. Further, on both sides, we notice a couple more pressure plates – these are already on the usual screws.
By the way, the developers propose the following (already familiar) formation of the “crown” of cotton.
In addition to the complete grid, you can give the desired shape using the complete tool – frames. However, it is not clear how magically the base of the mesh will be bent in such a (necessary) manner for the convenience of its fastening.