Digiflavor Drop Solo RDA

While the next interesting news creeps into my tentacles, I decided to share my opinion about the copies that were released a long time ago. The first version of this drip, in a double-stranded version, made a lot of noise, but it never fell into my hands. And here I simply could not ignore my favorite segment of single-spiral copies. At the same time, vague doubts about the construct, and, consequently, the taste transfer, did not leave me.

Digiflavor Drop Solo RDA

Case Material: Stainless Steel Atomizer
Type: RDA
Capacity: 1.5ml
Diameter: 22mm / 24mm with beauty ring
Height: 31.5mm with drip type / 24mm without drip type (metal dome)
Connector: 510, pin is gold-plated
Weight: 35.5g / with plastic dome 18g
Color: see photo below

Options
– Drop Solo RDA
– additional dome with drip type
– beauty ring
– pre-wound spirals 2pcs
– screwdriver
key – hex key
– spare origins
– spare screws
– squonk pin
– adapter for 510th drip types
– user manual
– certificate

Thepackagebundle is simply gorgeous, many thanks to the manufacturer for this. If you pull out a small tuft of cotton wool from an old mattress, then you will not need anything else to start.

The exterior of our hero is quite decent. This is a neat barrel with an abundance of notches and an engraved logo. I will not say that this is the height of design, but everything is aesthetically pleasing and not particularly catchy. Unless the drip type form adds a little charm.

There are two drip types in the set, both of the 810th landing. The first (preinstalled) looks good, works as well. However, there is no groove inside to collect condensate, I will not say that this is critical, but it would be better with it. The second is just a “sawn off” pipe, I don’t even want to pay attention to it, it is slightly higher than the first.

The top cap sits tight enough on the skirt, here you will come in handy risks for adjusting the side airflow. The internal processing is spherical, symmetrical step cutouts are visible in the lower part. By the way, the kit has a second (plastic) instance, which is absolutely identical to the metal one. By the way, the latter is quite thick.

There are also two side skirts – the plastic version is about 1.5mm lower than the metal one. The latter, by the way, is rather thick-walled, therefore this instance copes with heating quite confidently with any dome mounted. Thanks to the keys, both of them sit motionless on the base. On the sidewalls there are two symmetric grids of air intake holes, the geometry of which is slightly different – on the plastic version there are fewer. Airflow control is carried out simultaneously from each side, and what is most incomprehensible to me – the developers did not provide for overlapping holes on one side on any version of the dome.